This is a discounted product, sold per pound. You cannot choose a color or color combination. In terms of printing, it is a full-fledged filament. Everything is printable without any problems.
this is the so-called color change of spools
the material does not pass quality control
possible color variations or color instability deviations in the weight of the coil
the material may or may not be dried (drying temperatures can be found in the datasheet)
the tolerance of the string and the winding is OK
not packed in original packaging - may or may not be vacuumed - datasheet is available for download in the top menu of the site
ASA filament for 3D printers
Acrylonitrile styrene acrylate (ASA) is an excellent alternative to ABS.
The material has been specially developed to be more weather resistant as an alternative to ABS. ASA 3D filament is a fiber for 3D printers that is strong, rigid and relatively easy to print. The material is also very resistant to chemical influences and heat. ASA also has less deformation than ABS, but the material should not become too cold during printing.
Characteristic features
UV and weather resistance
Optimized for FDM (FFF) 3D printers
Excellent adhesion to heated board, Kapton, BuildTak, glass, etc.
Low shrinkage compared to ABS
Perfect adhesion of layers
Easy removal of supports
High thermal stability
Printing difficulty slightly higher than PLA or PET-G.
Generally easier printing compared to ABS.
Potentially hazardous fumes are produced during printing because ASA contains styrene
Can be glued and smoothed with acetone
The material excels in high adhesion to the substrate. Therefore, it is suitable to use, for example, kores or hairspray as a separator. Larger objects should be printed in a closed box to ensure slower cooling of the printout. This prevents rapid shrinkage and possible cracking of the layers.
Recommended temperatures apply to 0.4mm nozzle printing and a speed of approximately 60mm / s
For higher speeds, the temperature must be raised accordingly
For a nozzle with a larger diameter of 0.6 and more, the temperature must be increased to allow the plastic to melt
It is also possible to slightly increase the temperature for a larger object
The opposite is also true, lower speed, smaller nozzle, smaller object = lower hotend temperature
Cooling 0-30%. It is better not to cool a larger object at all
TIP
If you have trouble removing the printout from the tray, place the printout and tray in the refrigerator or freezer. If it still cannot be removed, put it in lukewarm water. The procedure can be repeated. When removing "by force", the pad may be damaged !!!
Filament parameters:
Weight of printing string 850 g
Length of the printing string approx. 340 m
Diameter 1.75 mm + - 0.02 mm
Print temperature 255-265 C
Heated bed temperature 105-115 C
The spool with the printing string is vacuum packed
Rozměry cívky s filamentem
Outer diameter 200 mm
Shaft bore diameter 52 mm
Coil width 70 mm
Filament package dimensions (box): 80 x 230 x 200 mm
Made in Czech Republic. This product is made of virgin granulate. It does not contain recycled material or other undesirable additives.